This is my first attempt at making beer. After I poured the wort into the fermenting jug I did a hydrometer reading and it was 1.034. According to the scale this was too low. Any ideas what I could have done wrong?
Ronnie
Hydrometer Reading
Moderator: slothrob
low OG
I assume you made an extract kit. If you hit the volumes correctly, then the OG will be what the kit predicted, because the amount of sugar in the kit is known.
It's very common, with these extract kits, that brewers get the wrong OG read from the hydrometer. This is because you are mixing the concentrated wort from the kettle with water. It is very difficult to get this mixed evenly enough to get a good hydrometer reading, even if you're sure you mixed it well. The reading is almost always low, because the concentrated wort wants to sit on the bottom.
The fermentation will get it mixed well, though.
It's very common, with these extract kits, that brewers get the wrong OG read from the hydrometer. This is because you are mixing the concentrated wort from the kettle with water. It is very difficult to get this mixed evenly enough to get a good hydrometer reading, even if you're sure you mixed it well. The reading is almost always low, because the concentrated wort wants to sit on the bottom.
The fermentation will get it mixed well, though.
BTP v2.0.* Windows XP
-
- Posts: 5
- Joined: Sat Nov 19, 2011 11:26 am
- Location: Trinity, NC
Low OG
Thanks. That answers my question. You are correct I did use the extract kit.