kegerator building
Moderator: slothrob
kegerator building
newbie to forum.question is .I am building a kegerator. from a full sized frige,does it matter if the co2 is on the inside or outside.would like to put on the outside, on the side with the tap on the front,to make room for more corney's inside.worried about hitting lines on the side.
- brewmeisterintng
- Strong Ale
- Posts: 384
- Joined: Thu Jan 13, 2005 8:47 pm
- Location: Clarksville, TN
Three holes
I have three holes in the side of my refrig. Two holes for taps and one for the CO2 line. I did a lot of research on my model and found where the lines were likely to be and worked around them. There are not as many as one would think. If you want to use caution, drilling a small hole through the skin and use a modified coat hanger to feel around before enlarging the hole and going all the way through might be a good idea. I also built a 9 inch platform for the frig to sit on so I didn't have to do any bending for my beer.
Besides taking up room in the frig, the CO2 canister will have a lower pressure at colder temperatures.
Besides taking up room in the frig, the CO2 canister will have a lower pressure at colder temperatures.
kegerator
thanks for the info,was also told some friges have plugs in them too but mine don't.I did e-mail the co. for info on it too.thought I had read that the co2 on the inside would show a low or incorrect pressure.going to build the same thing for mine, I will have to bend over a lot on mine to once the tap and handle are on and I won't have freezer clearence.
- brewmeisterintng
- Strong Ale
- Posts: 384
- Joined: Thu Jan 13, 2005 8:47 pm
- Location: Clarksville, TN
Tap Handles
My brother put his taps on the door of his refrigerator. I made him a pair of 7 inch tap handles so that they wouldn't interfer with the freezer door.
Re: Tap Handles
What did you make your handles out of.brewmeisterintng wrote:My brother put his taps on the door of his refrigerator. I made him a pair of 7 inch tap handles so that they wouldn't interfer with the freezer door.
bionome
- brewmeisterintng
- Strong Ale
- Posts: 384
- Joined: Thu Jan 13, 2005 8:47 pm
- Location: Clarksville, TN
Made them on a lathe
I bought the inserts at http://www.mcmaster.com/ so that they would fit on the taps. They are the same ones that NB sells but for a fraction of the cost. I made them out of walnut and maple.
I wish I knew how to post pictures as they did turn out beautiful.
I wish I knew how to post pictures as they did turn out beautiful.
tap handles
I made a few too. maple and figured maple were the local woods. The rest were from more ecotic peices like purple heart, paduk, blood wood etc. I also tried some made from a high quality plywood. It has seven layers per 1/4 inch. and them stacked them together for the thikness nedded. Turned out pretty cool. Some even were inset with the inlaws family crest. That one was presented to my brother-in-law for his St. Patricks day party.
Now back to the kegerators.
Now back to the kegerators.
"B"